Robomow RS models mowers have three (3) error list types: Last Stop Cause / Operation Stop Reason System Failure Built In Test (BIT) In the event that you encounter any...
RS Model FAQs
Built In Test for Easy Diagnosis
BIT was developed for easy diagnosis, to display errors that occur during test procedures and internally. The idea is that a 2-6 digit error code will pinpoint the failure. This...
Mower Cover Doesn’t Lock In
Step 1 – Remove the mower cover and inspect the metal rod ends – the ones the cover locking arms snap on to. See picture below for the metal rod...
Red Light Blinking Slow on the Base Station Head / Wire Too Long Warning
Step 1 – Is it a new installation or have changes been made in the lawn/installation cable recently? If Yes – Make sure the installation was done according the written...
Not Going to Sub Zone when Setting Up
Step 1 – This could be a case where bumper calibration is needed. Take the mower out of the base station and perform Bumper Calibration through Service ⇢ 897 ⇢...
Mow Overheat, Overcurrent or Disconnected Message
These messages can be displayed on the docking while warming up or during any operation, automatic or manual. “Overheat Cooling” Message If you see this message, this is a normal...
Base Station Head light is steady red
Step 1 – Make sure the Power Supply is connected well and that there is power in the wall outlet. If Yes – Proceed to Step 2. If No –...
Base Station Head light does not operate or is dead / No light at all
Step 1 – Make sure the Power Supply is connected well and that there is power in the wall outlet. If Yes – Proceed to Step 2. If No –...
Front Wheel Problem Message
Step 1 – Was the mower found stuck mid-yard and the front wheel dropped down into a ditch, hole in the ground, or front of the mower sitting raised up...
Mower Does Not Start Automatic Mowing
Step 1 – Press the up-arrow button (3 seconds) on the mower while it is in the base station to receive a code which is the reason the mower didn’t...