This is a warning of a cut wire. In such cases there is no signal in the lawn and the scissors LED may be blinking. Troubleshoot this warning by following...
Troubleshooting FAQs
The scissors LED is blinking
When the scissors LED blinks, it is an indicator that there is an issue with the wire being cut, being too long or causing a bad connection. Follow the links...
(E5) Check blade / Cutting height message
For RC Models Q1 – Is it the first cut of the season or is the grass very high? If Yes – Lift the mowing height level and let the...
Poor quality of cut and damage to the lawn (RC Models)
Q1 – Is it the first cut of the season or is the grass very high? If Yes – It is recommended to cut less than a 1/3 of the...
Mowing time is very short (Short Run Time). What should I do? (RC Models)
Q1 – Did you observe this error more than once lately? If Yes – Proceed to Q2. If No – Press the ‘OK’ button for 3 seconds and set the...
The robot stops after a few minutes in the Separated Zone with U017
For RC Models U017 – Time Completed Message Make sure the program is set to On according to the steps below. There are two options to change the program to...
The LCD is blank and will not turn on, no matter what button I press. What should I do?
For RC Models Q1 – Are you using the Robomow App on your smart phone/device? If Yes – Launch the App and send the robot to mow. If the robot...
Bumper pressed (43) (62)
This article is intended for Robomow professional dealers. For RS Models Problem or Cause Corrective Action Automatic operation was stopped since bumper is constantly being pressed for too long Operate...
Right Drive Motor is disconnected (222)
This article is intended for Robomow professional dealers. For RS Models Right Drive Motor disconnection is detected. Problem or Cause Corrective Action Drive motor connector is not well connected Disconnect...
Mow Motor is disconnected
This article is intended for Robomow professional dealers. For RS Models Problem or Cause Corrective Action There is poor contact in one of the pins in the mow motor cable...