This article is intended for Robomow professional dealers. For RS and RC Models Battery cells are not balanced and do not reach the required state after charging for a long time...
Troubleshooting FAQs
Switch off before lifting (25)
This article is intended for Robomow professional dealers. For RS and RC Models Tilt is detected for more than 5 seconds. Problem or Cause Corrective Action Robot climbed on a...
System Switch is off (26)
This article is intended for Robomow professional dealers. For RS and RC Models Problem or Cause Corrective Action Safety/System switch is Off when the robot is in charging mode Turn...
High mow current
This article is intended for Robomow professional dealers. For RS and RC Models Mowing motor has faced an over-current for too long. CAUTION – Switch off the Safety Switch before...
Why is my robot running around without mowing?
There are few reasons for the robot to stop mowing and start searching for the base station: Rain detected Mowing time completed Inactive time Recharge battery Technical issue There are...
Mow overheat (27)
This article is intended for Robomow professional dealers. For RS and RC Models Mowing motor has faced an over-current for too long. CAUTION – Switch off the Safety Switch before...
Can my robot get the latest software version?
Based on your Robomow model and configuration year, you can upgrade your mower to the latest software version as listed below. For RC Models Configuration Year Software Version 2014 1.81...
The Robomow RS robot continues to mow even though there is heavy rain
The following is the robot’s behavior when rain is detected: Islands On: The moment rain is detected by the robot, it will wait about 1 minute to make sure it is...
The Robomow RC robot continues to mow even though there is heavy rain
The following is the robot’s behavior when rain is detected: Islands On: The moment rain is detected by the robot, it will wait about 1 minute to make sure it is...
Robomow stops with no message or does not wake up
For RC Models Step 1 – Did this happen more than once? If Yes – Proceed to Step 2. If No – Let the robot continue to work, and if...